Films

Is it important to the yield of stretch film to have the pre-stretch rollers clean?

Should the top of the load be wrapped tighter than the middle or bottom of the load.

Can there be too much load containment force?

Do the typical pre-stretch gears on stretch wrapper exceed 200%?

With machine grade stretch film, does the stretch film get stretched any further after it leaves the carriage of the stretch wrapper?

Can thicker or more expensive film be more economical for the end-user?

Typically, does cast or blown film make noise when being applied to the load?

Which of the following is most commonly used to unitize a pallet of goods?

Can stretch film be recycled?

Is it best to tie the load to the pallet by using the stretch film?